PA stretch problem
Over about four years I've stretch my PA to 6mm. Most stages were
autostretched; only one or two caused any discomfort.
Recently I tried to go to 8mm & failed so I opted for 7mm which while
tight caused no discomfort even.
After only a week I tried 8mm & it went in with some minimal pain - bear
in mind I'm a wuss, so it can't have been that bad.
Immediately after insertion it wouldn't turn without lube & a similar
level of pain.
I expected the tenderness to gradually decrease, but instead over three
days it's got more painful. Today I noticed a slight odourless white
discharge & going for a pee burned for the first time this morning. The
ring however will now gently turn without lube.
I just wanted to check this doesn't indicate my dick is about to drop
off - that's one body mod too far for me.
I /think/ this has probably just been more than my body wanted to cope
with at once & it's responded by rapidly growing new skin, leaving
sensitive open new flesh & the old skin cells sloughing off at an
accelerated rate, but I thought I should check.
I intend treating it as a new piercing with salt water soaks & making
sure I drink plenty of fluids. If anyone reckons I ought to do something
else or drop back to 7mm, please advise.
I'm a little concerned as the ring is obviously more heavy which makes
the potential for self damage greater than before while it's tender
(surgical steel, 8mmx15mm with 10mm ball). Also at 8mm thick it occupies
a much greater proportion of the urethra's cross section, potentially
causing a blockage (though prior to this problem I had thought it would
be fine - it's not as though it stops me peeing).
Thanks for any reassuring comments or warnings of impending doom.
--
Michael
m r o z a t u k g a t e w a y d o t n e t
|